Ducati Hyperstrada Forums Ducati Hyperstrada Motorcycle

Go Back   Ducati Hyperstrada Forum > Ducati Hyperstrada Forum > Mechanical and Technical

Mechanical and Technical Mechanical and technical topics, help, and discussions

LinkBack Thread Tools Display Modes
Old October 1st, 2019, 06:21 AM   #1
Senior Member
Joined: Sep 2017
From: Lansing Mi
Posts: 243

I Ride: 2013 hypermotard/hyperstrada, 2005 zx6r, drz125, crf50 crf70
3D printed swingarm plug

Does this also fit the Hyper? If not someone should come up with a 3D printed file for them. Seems like an easy money maker(not alot of money but some money). It basically covers the big hole at the front of the swingarm pivot point. That is were most of the grime, rocks and water is let in and then sets at the rear carrier bearing causing corrosion.
Araitim is offline   Reply With Quote

  Ducati Hyperstrada Forum > Ducati Hyperstrada Forum > Mechanical and Technical

plug, printed, swingarm

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Swingarm pivot bolt / rod removal mikejuice Mechanical and Technical 1 August 5th, 2019 06:49 AM
3D printed GoPro mount Masanori Ducati Hyperstrada 19 January 16th, 2017 10:02 PM
fs: Ducati single sided swingarm stand Superbike Italia Classifieds 3 November 8th, 2015 02:01 PM
3D Printed parts Joecati Ducati Hyperstrada 6 October 3rd, 2015 06:11 PM
Rizoma Swingarm Plate TitoZilla Ducati Hyperstrada 8 July 24th, 2014 07:36 AM

Ducati Hyperstrada Facebook Ducati Hyperstrada Twitter Ducati Hyperstrada RSS Feed

Ducati Hyperstrada Motorcycle Forum
Copyright © 2012-2014 HYPERSTRADA.COM • All rights reserved.